Multipass on a per path basis was really nice. You could also do island fills and hatch fills, peck cuts, and ingrave cuts. What was really nice about this was it would auto-weld or attempt to close loops if a path was not already closed and gave good visual cues to help isolate the problems. Then selecting the closed lines I could choose to path it as a exterior or interior cut and whether I wanted it to auto tab based on distance, count or manually and the feed speeds could be tuned per cut. It was smart enough to let me mix and match unit types. I used the libraries to set up for different foam thicknesses so when I imported my file (usually EPS from Illustrator, or DWGs from AutoCAD or Sketchup), I told it that I wanted to set the job up for 3.2mm Depron (Depron isn't always the same thickness!) using a. You created material, tool and path libraries that made code generation very easy, and the interactive tabbing is really rock solid. What I really loved about it was how everything was based on libraries. Some users on the cnczone have used it with the eas圜NC boards before and reported that you can generate gcode with the TechnoTC post-processor that is compatible. I don't have a Phlatprinter yet but I intend to try it out when the time comes as it is really fast and generates very reliable g-code. It's pretty high dollar, I'm just lucky enough to have an NFR copy from a sales rep from a few years ago. Not sure if anyone has tried this before but I have a bit of experience with using Enroute on a large MultiCAM table before and found a really good program.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |